EMC D-PWF-OE-00 Practice Test Questions Answers

To ensure the "proper integration" (meaning the add process succeeds without breaking the cluster):

Verify hardware compatibility (Option A): You must ensure the new nodes have the same CPU/RAM profile and, crucially, the same Drive Type/Capacity as existing nodes. Adding a hybrid node to an All-Flash cluster, or a node with incompatible firmware, can cause performance degradation or instability.

Validate network connectivity (Option B): Before the PowerFlex software can even be installed or added to the cluster, the nodes must have valid IP addresses and be able to communicate with the MDM over the management and data networks (checking MTU, VLANs, and routing).

To utilize Fault Sets effectively for their intended purpose (rack-level fault tolerance), the cluster architecture imposes specific minimums.

PowerFlex relies on distributing data copies (Mesh Mirroring). The standard redundancy scheme creates 2 copies of data. To ensure that data remains available even if one entire Fault Set (e.g., an entire rack) fails, the system must be able to distribute the mirrors across different Fault Sets. Consequently, you generally need a minimum of 3 Fault Sets (System requires 3+ Fault Sets to support 2-copy layouts effectively). Since a Fault Set must contain at least one node, the cluster requires a minimum of 3 nodes to support a Fault Set configuration.

The Metadata Manager (MDM) cluster is the critical control plane of PowerFlex.

Maintain redundancy for metadata storage (Option D): The MDM cluster (typically 3 or 5 nodes) must always maintain a quorum. When reconfiguring or expanding the management capabilities, you must ensure that there are enough replicas (Primary, Secondary, Tie-Breakers) to survive a node failure without bringing down the cluster management.

Ensure even distribution (Option A): Best practice dictates that MDM roles should be distributed across different failure domains (different racks or chassis) to prevent a single physical failure (like a rack power outage) from taking down the entire MDM cluster simultaneously.

Incorrect Options: MDMs are not assigned to Fault Sets (C)—Fault Sets are for SDSs. Replication protocols (B) are relevant for data disaster recovery, not for the local cluster MDM expansion.

True: After the initial software deployment (Day 0), the system consists of installed MDM/SDS software but no logical storage structure.

Day 1 Tasks: The administrator's first tasks are to:

Create a Protection Domain (grouping the SDS nodes).

(Optional but recommended) Configure Fault Sets within that Protection Domain for rack awareness.

Create Storage Pools within the PD.

Add Devices (Drives) to the Pool.

Only after these "post-installation" tasks are complete can volumes be created and mapped to hosts.

PowerFlex Manager (PFxM) is the orchestration and automation appliance.

Automate deployment and lifecycle management (Option B): PFxM is designed to take bare-metal servers and automatically deploy the OS, networking, and PowerFlex software to build a cluster. Once built, it handles the Lifecycle Management (LCM), automating complex tasks like firmware upgrades, software patches, and node expansions without downtime.

Incorrect Options: Managing VMs (A) is for vCenter. Creating snapshots (C) and configuring Fault Sets (D) are storage tasks performed via the PowerFlex GUI/Block Controller, whereas PFxM focuses on the infrastructure lifecycle.