Summer Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: s2p65

Easiest Solution 2 Pass Your Certification Exams

ECP-383 Ericsson Certified Associate - Radio Network Optimization Free Practice Exam Questions (2025 Updated)

Prepare effectively for your Ericsson ECP-383 Ericsson Certified Associate - Radio Network Optimization certification with our extensive collection of free, high-quality practice questions. Each question is designed to mirror the actual exam format and objectives, complete with comprehensive answers and detailed explanations. Our materials are regularly updated for 2025, ensuring you have the most current resources to build confidence and succeed on your first attempt.

Page: 1 / 1
Total 62 questions

Which two channel bandwidths are available in LTE? (Choose two.)

A.

2.8 MHz

B.

1.4 MHz

C.

30 MHz

D.

15 MHz

Which element is used in maintaining a 4G VoLTE call leg?

A.

NodeB

B.

PSTN

C.

P-GW

D.

BSC

You are performing a drive test on a cluster carrying commercial WCDMA traffic using a drive testing tool.

What are two metrics that would be detected using this tool? (Choose two.)

A.

packet throughput

B.

RNC processor load

C.

channel element utilization

D.

speech accessibility

What are two benefits provided by the introduction of GPRS/EGPRS Downlink Power Control in a GSM network? (Choose two.)

A.

reduced power consumption in RBS

B.

reduced downlink Interference levels In the system

C.

reduced uplink interference levels in the system

D.

increased PS accessibility

Which two benefits does OSS counter-based optimization provide compared to drive test measurements? (Choose two.)

A.

OSS counters capture the indoor performance.

B.

OSS counters allow throughput measurements in cells where no traffic is carried.

C.

OSS counters only capture the outdoor performance.

D.

OSS counters provide OPEX cost savings.

Which two characteristics are true about 30 GHz spectrum compared to 2100 MHz spectrum? (Choose

two.)

A.

It has improved in building penetration coverage.

B.

It has a reduced antenna separation distance required for effective MIMO.

C.

It has reduced in building penetration coverage.

D.

It has an increased antenna separation distance required for effective MIMO.

After the installation of a new LTE antenna on a roof top, UL interference power for that sector is observed.

In this scenario, which two situations would cause the interference? (Choose two.)

A.

Equipment that generates electrical magnetic fields are in the same location.

B.

The antenna was placed on a mast near the edge of a rooftop.

C.

A plastic enclosure was placed to cover the antenna.

D.

Reflective objects such as metal chains or metal ladders were placed in front of the antenna.

A customer is deploying VoLTE and complains about high voice drop rates and voice quality degradation at the cell edge in most LTE cells in the area. The network has a dense WCDMA coverage on the 700 MHz band and patchy LTE coverage on the 2100 MHz band.

Which two features would you activate to solve this problem? (Choose two.)

A.

DRX

B.

256 QAM DL

C.

TTI Bundling

D.

SRVCC Handover to UTRAN

You are performing a physical parameter optimization of an LTE network with an automatic tool that uses propagation predictions. As a result, the tool estimates an increase of RSRP from cell A at a particular location.

In this scenario, what has happened?

A.

Signal attenuation from the transmitter to the location has increased.

B.

The antenna pattern of cell A has changed.

C.

The PRB utilization of cell A has decreased.

D.

Soft handover factor has increased.

Using a cell optimization tool, you detect a sector that takes a large amount of traffic from a distant location that is covered by other sites and is also outside of the coverage predicted for this sector.

Which physical optimization action should you perform first In this situation?

A.

Increase the antenna height and verify the result.

B.

Install TMA and verify the result.

C.

Downtilt the antenna and verify the result.

D.

Increase the transmit power and verify the result.

Which two use cases are specifically targeted for 5G technology? (Choose two.)

A.

multi tabbed Web browsing

B.

massive machine-type communications

C.

remote controlled machines

D.

asynchronous transfer mode backhaul

An operator receives customer complaints from an indoor location. The Issues result from a bad neighbor plan in a single RAT and frequency network.

Which two optimization processes would you use to resolve the problem? (Choose two.)

A.

call trace based neighbor optimization

B.

drive test based neighbor optimization

C.

PM counter based neighbor optimization

D.

prediction based neighbor optimization

Caller A is on a VoLTE call with Caller B. Suddenly Caller A is no longer able to hear Caller B but Caller B can hear Caller A.

Which two call legs and directions should be analyzed first in this scenario? (Choose two.)

A.

the Caller B downlink

B.

the Caller A uplink

C.

the Caller A downlink

D.

the Caller B uplink

What is a benefit of soft handover?

A.

It decreases channel element usage.

B.

It ensures successful handover among detected cells.

C.

It reduces the connected user load of neighboring cells.

D.

It decreases interference.

You are using the Performance Measurements system for Ericsson WCDMA network analysis and must use predefined counters.

On which two levels would these counters be collected? (Choose two.)

A.

the cell level

B.

the TRX level

C.

the RNC level

D.

the BSC level

According to IR.92, which two LTE RAN functions are required to support VoLTE? (Choose two.)

A.

Service Specific Inactivity Timer

B.

RLC in Unacknowledged Mode for RTP transmissions

C.

Inter-frequency handover

D.

Multiple Radio Bearers per User

Which three service KPIs (S-KPIs) are obtained by DT measurement? (Choose three.)

A.

bearer drop rate

B.

handover success rate

C.

additional status total time for social media

D.

initial buffering time for video

E.

interactive time for Web browsing

A user is making a call on an LTE network.

In this scenario, which encoding schemes are used?

A.

OFDMA in downlink, COMA in uplink

B.

CDMA in downlink, SC-FOMA in uplink

C.

SC-FDMA in downlink, OFDMA in uplink

D.

OFDMA in downlink, SC-FDMA in uplink

Page: 1 / 1
Total 62 questions
Copyright © 2014-2025 Solution2Pass. All Rights Reserved