Weekend Sale - Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: xmaspas7

Easiest Solution 2 Pass Your Certification Exams

201 F5 TMOS Administration Free Practice Exam Questions (2025 Updated)

Prepare effectively for your F5 201 TMOS Administration certification with our extensive collection of free, high-quality practice questions. Each question is designed to mirror the actual exam format and objectives, complete with comprehensive answers and detailed explanations. Our materials are regularly updated for 2025, ensuring you have the most current resources to build confidence and succeed on your first attempt.

Page: 3 / 4
Total 254 questions

A site is load balancing to a pool of web servers. Which statement is true concerning BIG IP's ability to verify whether the web servers are functioning properly or not?

A.

Web server monitors can test the content of any page on the server.

B.

Web server monitors always verify the contents of the index.html page.

C.

Web server monitors can test whether the server's address is reachable, but cannot test a page's content.

D.

Web server monitors can test the content of static web pages, but cannot test pages that would require the web server to dynamically build content.

A BIG-IP Administrator sees the following error message in /var/log/ltm diskmonitor: *******; Disk partition shared has less than 30$ free

Which section of the Configuration Utility should the BIG-IP Administrator access to investigate this

error message?

A.

Statistics > Analytics

B.

System > File Management

C.

Statistics > Module Statistics > System

D.

System > Disk Management

A BIG-IP Administrator wants to add a new Self IP to the BIG-IP device. Which item should be assigned to the new Self IP being configured?

A.

Interface

B.

Route

C.

VLAN

D.

Trunk

A BIG-IP Administrator runs the initial configuration wizard and learns that the NTP servers were invalid. In which area of the Configuration Utility should the BIG-IP Administrator update the list of configured NTP servers?

A.

System > Configuration

B.

System > Services

C.

System > Preferences

D.

System > Platform

The ICMP monitor has been assigned to all nodes. In addition, all pools have been assigned custom monitors. The pool is marked available. If a pool is marked available (green) which situation is sufficient to cause this?

A.

All of the pool member nodes are responding to the ICMP monitor as expected.

B.

Less than 50% of the pool member nodes responded to the ICMP echo request.

C.

All of the members of the pool have had their content updated recently and their responses no longer match the monitor.

D.

Over 25% of the pool members have had their content updated and it no longer matches the receive rule of the custom monitor. The other respond as expected.

The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B. Given the virtual server and pool definitions and the statistics shown in the graphic, which member will be used for the next connection?

A.

10.10.20.1:80

B.

10.10.20.2:80

C.

10.10.20.3:80

D.

10.10.20.4:80

E.

10.10.20.5:80

Assume a virtual server is configured with a ClientSSL profile. What would the result be if the virtual server's destination port were not 443?

A.

SSL termination could not be performed if the virtual server's port was not port 443.

B.

Virtual servers with a ClientSSL profile are always configured with a destination port of 443.

C.

As long as client traffic was directed to the alternate port, the virtual server would work as intended.

D.

Since the virtual server is associated with a ClientSSL profile, it will always process traffic sent to port 443.

A BIG-IP Administrator needs to apply a health monitor for a pool of database servers named DB_Pool

that uses TCP port 1521.

Where should the BIG-IP Administrator apply this monitor?

A.

Local Traffic > Profiles ยป Protocol > TCP

B.

Local Traffic > Nodes > Default Monitor

C.

Local Traffic > Pools > De Pool > Members

D.

Local Traffic > Pools > DB Pool > Properties

Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system. Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?

A.

The Connection Rate Limit is set too high

B.

The server SSL Profile has NOT been reconfigured.

C.

The Connection Limit is set too low.

D.

The Rewrite Profile has NOT been configured.

A BIG-IP Administrator finds the following log entry after a report of user issues connecting to a virtual server:

01010201: 2: Inet port exhaustion on 10.70.110.112 to 192.28.123.250:80 (proto 6)

How should the BIG-IP Administrator modify the SNAT pool that is associated with the virtual server?

A.

Remove the SNAT pool and apply SNAT Automap.

B.

Remove an IP address from the SNAT pool.

C.

Add an address to the SNAT pool.

D.

Increase the timeout of the SNAT addresses.

A BIG-IP Administrator contacts F5 Support, which identifies a suspected hardware failure. Which information should the BIG-IP Administrator provide to F5 Support?

A.

Qkview, EUD output

B.

Qkview, UCS archive, core files

C.

Qkview, part numbers for failed components

D.

Qkview, packet capture, UCS archive

What is the status of a pool member when manual resume is enabled and a health check first fails and then passes?

A.

Offline (Disabled)

B.

Offline (Enabled)

C.

Available (Disabled)

D.

Available (Enabled)

Refer to the exhibit.

Which TMSH command generated this output?

A.

tmsh list /cm sync-status

B.

tmsh show /sys sync-status

C.

tmsh list /sys sync-status

D.

tmsh show /cm sync status

Which VLANs must be enabled for a SNAT to perform as desired (translating only desired packets)?

A.

The SNAT must be enabled for all VLANs.

B.

The SNAT must be enabled for the VLANs where desired packets leave the BIG-IP.

C.

The SNAT must be enabled for the VLANs where desired packets arrive on the BIG-IP.

D.

The SNAT must be enabled for the VLANs where desired packets arrive and leave the BIG-IP.

A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

A.

Assign two Interfaces to the VLAN

B.

Set the media speed of Interface 1.1 manually

C.

Create a trunk object with two Interfaces

D.

Increase the MTU on the VLAN using Interface 1.1

Refer to the exhibit.

During a planned upgrade lo a BIG-IP HA pair running Active/Standby, an outage to application traffic is reported shortly after the Active unit is forced to Standby Reverting the flower resolves the outage. What should the BIG-IP Administrator modify to avoid an outage during the next for over event?

A.

The Tag voice on the Standby device

B.

The interface on the Active device to 1.1

C.

The Tag value on the Active device

D.

The Interface on the Standby device to 1.1

A 8IG-IP device is replaced with an RMA device. The BIG-IP Administrator renews the license and tries to restore the configuration from a previously generated UCS archive on the RMA device. The device configuration is NOT fully loading. What is causing the configuration load to fail?

A.

The Device Group is NOT configured for Full Sync.

B.

The US does NOT contain the full config

C.

The clock is NOT set correctly

D.

The Master Key is NOT restored

A BIG-IP Administrator needs to find which modules have been licensed for use on the BIG-IP system. In which section of the Configuration Utility can the BIG-IP Administrator find this information?

A.

System > Services

B.

System > Resource Provisioning

C.

System > Platform

D.

System > Support

How should a BIG-IP Administrator persistent sessions from being sent to a pool member so that the server administrator can perform maintenance?

A.

force the pool member offline

B.

disable the pool member

C.

add an additional monitor to the poor

D.

disable the virtual server

A BIG-IP Administrator configures a Virtual Server. Users report that they always receive a TCP RST packet to the BIG-IP system when attempting to connect to it. What is the possible reason for this issue?

A.

The virtual server Type is set to Internal

B.

The virtual server Type is set to Reject

C.

The virtual server Type is set to Drop

D.

The virtual server Type is set to Stateless

Page: 3 / 4
Total 254 questions
Copyright © 2014-2025 Solution2Pass. All Rights Reserved